FDON Replacement Slewing Bearing Case | Indonesia
Replacement Engineering Case · Indonesia
From an Existing Roballo Slewing Ring to a Confirmed Replacement Drawing

The customer had an old slewing ring but no complete production drawing. FDON first confirms the main dimensions, then checks the mounting holes and gear interface, prepares a draft drawing for customer review, and only after approval releases the final drawing for manufacturing.

Preliminary Identification
What we can identify
  • Brand: Roballo Slewing Ring
  • Visible code: 9777-004-207 / 6008020-26
  • Likely structure: external-gear slewing ring, probably single-row ball / four-point contact
  • Customer annotation: about 67 in ≈ 1702 mm overall size
  • Customer annotation: about 42 in ≈ 1067 mm inner opening
Still to confirm
  • Overall height
  • Mounting-hole quantity
  • Threaded or through holes
  • Hole/thread size
  • PCD
  • Gear tooth count
  • Module / DP
  • Opposite-side interface
Customer Photos
Preliminary Dimension Check
Important: these figures are preliminary only. FDON will not release a production drawing until the customer confirms each critical dimension.
TypeExternal-gear slewing ring
Estimated OD≈ 67 in ≈ 1702 mm
Estimated inner opening≈ 42 in ≈ 1067 mm
Estimated radial build≈ 317.5 mm if both annotations are correct
Mounting holesAt least some visible holes appear threaded. Quantity, size and PCD must be measured.
GearExternal spur gear. Tooth count and module / DP still need confirmation.
FDON Measurement Sheet

The customer fills in the dimensions first. FDON then prepares a replacement drawing for review.

Replacement Workflow
1
Measure
Customer fills key dimensions.
2
Draft
FDON prepares a replacement drawing.
3
Review
Customer checks dimensions, holes and gear data.
4
Confirm
Final drawing is frozen after approval.
5
Manufacture
FDON machines and inspects the bearing.
Send Drawing / Model / Application Details
steven@slewingbearings.com